Functions And Operation - motogadget m.unit blue Operating And Installation Manual

6 Functions And Operation

The m-Unit is able to act as central control unit in the vehicle's electrical system. It provides
following features:
Without smart phone:
•
Complete digital push button control unit; optional 4 or 5 push button operation
•
complete replacement of all OEM fuses 10 independent circuits are digitally supervised; a
circuit will be shut down in case of interferences after removing the interference, the safety
feature will be reset automatically
•
integrated, digital, load-independent flasher relay; with programmable switch-off feature
(optional), selectable m-Wave mode
•
turn signal setting for use as position light
•
parking light, headlight flasher
•
integrated digital brake-light modulator with programmable flashing sequence, acceleration-
controlled emergency brake-light
•
pairing of m-unit with other motogadget products via LIN bus
•
integrated starter relay for solenoid switch (up to 30A switching capacity)
•
smart and fully configurable load control / shut-off for maximum starting power of battery on
starting process
•
low beam and high beam control (up to 200W switching power) using just one push button
•
integrated digital horn relay
•
integrated position-independent alarm system
•
integrated hazard light feature
•
diagnostic feature for layout of input, output, circuit switching status, diagnosis of short-circuits
etc.
•
two fully configurable auxiliary outputs AUX1 and AUX2
Pairing of m-unit with your smart phone via Bluetooth in combination with our „m.garage"
app providing advanced functionality:
•
Pairing via Bluetooth LE (Low Energy); therefore extremely low power consumption of vehicle
and smart phone cell
•
reporting of alarm events (date, time, vehicle „down" etc.) to smart phone
•
real-time analysis of all inputs / outputs, measurements of currents, voltage, temperature
•
manual switching of outputs using m.ride app (except starter)
•
firmware updates from any location
•
configuration of setup menu using m.ride app
•
Keyless Go feature using encrypted and secure pairing with your smart phone
•
speedometer input is compatible with all standard vehicle speedometer inputs and
automatically calibrates via smart phone GPS
•
the m.unit's speedometer input for storage and matching of vehicle's odometer enables for
vehicle management with an overview of maintenance tasks and states of wheels, chain,
brake pads, oils, operating supplies, spark plugs etc.
•
logging of states, alarms and maintenance
•
fully automatic driver's logbook
•
display of parking position and „ping" feature for locating your vehicle
•
calibration and accurate current measurement enable detection of defective LED turn signals
and all standard illuminants
The m.unit is made of a newly designed high-performance thermosetting plastic and resistant to
moisture, heat, cold and vibrations. Microprocessor operated and supervised circuits guarantee
highest reliability. Current flow of each circuit is measured with high accuracy. In case of failure like
a short-circuit the concerning loop will be shut down in a split second. All switching activities are
carried out by state of the art semiconductor switches in a fast, wear-free and almost lossless way.
4