Camera Presets - Storing; Camera Presets - Accessing - Polycom The Remote Control User Manual

Camera Presets - Storing

It is suggested that all camera presets be done before starting a videoconference. A total of
10 presets are available.
Y C :
OUR AMERA
The camera icon in the top right corner should be pointing towards you. If not,
press the NEAR button.
Frame the individual(s) or objects using the ZOOM button and
DIRECTIONAL buttons.
F E C :
AR ND AMERA
The camera icon in the top right corner should be pointing away from you. If
not, press the FAR button.
Frame the individual(s) or objects using the ZOOM button and
DIRECTIONAL buttons.
To set your camera presets:
1. Press the PRESET button on the remote.
2. Press the number that you want to assign the preset set to.
3. The screen will display a message saying, "Preset X stored" (where X is the number
you assigned).
4. Test your preset by moving your camera to a different view, then press the number
you assigned to the preset. The camera should move to the pre-programmed
position.
Note: If you physically move the PolyCom EX system, the presets may need to be reset.
Camera Presets – Accessing
Y C :
OUR AMERA
The camera icon must be facing you. Select numbers 0-9 on the remote
control. The camera will automatically move to the pre-programmed position.
F E C :
AR ND AMERA
The camera icon must be pointing away from you. The camera will
automatically move to the pre-programmed position.
PolyCom EX User Manual
The information herein may be reproduced provided that it is accurate and NORTH Network is credited as the source.
Aug. 18, 2004 v 1.1
Copyright © NORTH Network 1998.
Page 10 of 13