Table of Contents
Advertisement
2
Getting Started
2.1
Section overview
This section provides help on unpacking the Verifit and connecting various
components and accessories and on installing the CD-ROM.
The following topics are covered in this section:
2.2: Unpacking and connecting
2.3: CD-ROM installation
2.4: Microphone connection
2.5: Microphone care
2.6: Battery pill use and care
2.7: Mouse, keyboard, barcode scanner
2.8: External display, printer, speaker
FastFacts 2.1: Getting started
2.2
Unpacking and connecting
1) Carefully unpack the two parts of the Verifit and check the contents of the
shipping box against the enclosed packing list. Note that some parts may be
packed inside the test chamber.
2) Connect the two 15 pin cables from the connectors on the rear of the test
chamber to the connectors on the front of the main display unit as shown. The
top side of each connector is labeled to assist you. Take care not to force the
connectors as the pins are easily bent. Both short (as shown) and long
cables are provided for flexibility in locating the two parts of the instrument.
3) Connect the power cord to the socket next to the power switch on the left side
of the main display unit. Plug the other end into a grounded 100 – 240 volt
power outlet.
FastFacts 2.2: Unpacking and connecting
0611
Verifit User's Guide Version 2.8
Page 11
Advertisement
Table of Contents
