Getting Started; Unpacking And Connecting - audioscan Verifit VF-1 User Manual

2 Getting Started

This section provides instructions for unpacking the Verifit and connecting various components and associated
items.

Unpacking and connecting

WARNING: To avoid the risk of electrical shock, use only the power cord supplied with the Verifit and
connect it only to a grounded (protectively earthed) electrical outlet.
WARNING: To allow electrical power to be rapidly disconnected in the event of an emergency, position the
Verifit in an accessible location so that the power cord may be quickly disconnected.
WARNING: To ensure that the operation of this product is not affected by EMC emissions from other
products, this product should not be used adjacent to or stacked on other equipment. If this is necessary, its
operation should be verified as normal in this configuration. Portable and mobile RF communications
equipment can affect the performance of this product
Use only an approved test box cable to connect the test box and the display unit.
The test box can only be connected to the display unit.
Failure to follow operating instructions could place the user or operator at risk.
1. Carefully unpack the two parts of the Verifit and check the contents of the shipping box against the enclosed
packing list. Note that some parts may be packed inside the test chamber.
2. Connect the two 15 pin cables from the connectors on the rear of the test chamber to the connectors on the
front of the main display unit as shown. The top side of each connector is labeled to assist you. Take care not
to force the connectors as the pins are easily bent. Both short (as shown) and long cables are provided for
flexibility in locating the two parts of the instrument.
User's Guide Version 3.12 © November 2015
®
Verifit
14