Command Technologies COMMANDER VHF-2000 Manual page 6

CAUTIONS
Do not attempt any type of service or repair on this Amplifier
without first removing the AC power and allowing at LEAST
60 MINUTES FOR THE HIGH VOLTAGE CAPACITORS
TO BLEED OFF !
Make no attempt to put this Amplifier in service with the top
or bottom covers removed. CONTACT WITH VOLTAGES IN
THE CABINET CAN BE FATAL !
Never attempt operation without first connecting an
appropriate antenna (2.0:1 VSWR Max) or a 50 ohm load
with sufficient rating or SERIOUS DAMAGE TO THE
AMPLIFIER MAY RESULT.
Never operate unit with more drive than required to produce
the rated output for the operating mode used.
Do not place the Commander VHF-Amp. in Repeater
operation. Extensive modification would be required for this
type of service.
Never operate any Amplifier using an extension cord.
Never cover the top of the Amplifier cabinet with books,
papers or other equipment as OVERHEATING MAY
RESULT.
IF ANY PROBLEM OCCURS NOT EASILY CORRECTED,
PLEASE CONTACT MANUFACTURER FOR
ASSISTANCE.
800-736-0443 419-459-4689