Table of Contents
Advertisement
User Manual
There are two ways for the wireless client to establish the connection with the modem
through WPS. The modem generates PIN, see the above figure. Click Regenerate PIN to
generate a new PIN, and then click Start PBC, In the wireless client tool, enter the PIN
which is generated by the modem, start connection. The client will automatically
establish the connection with the modem through the encryption mode, and you need
not to enter the key. The other way is the wireless client generates PIN. In the above
figure, enter PIN of the wireless client in the Client PIN Number field, then click Start PIN
to establish the connection.
Note:
The wireless client establishes the connection with the modem through WPS
negotiation.The wireless client must support WPS
4.2.
Advanced
In the navigation bar, click Advanced. The tab Advanced contains Route, NAT, QoS,
CWMP, Port Mapping and Others.
4.2.1.
Route
Choose Advanced > Route, the page shown in the following figure appears. The page that
is displayed contains Static Route, RIP.
4.2.1.1. Static Route
Click Static Route in the left pane, the page shown in the following figure appears. This
page is used to configure the routing information. You can add or delete IP routes.
Advertisement
Table of Contents
