Charging The Battery Pack; Adjusting The Headset - Plantronics CT10 Owner's Manual

OPERATION
- continued

CHARGING THE BATTERY PACK

When you first use the phone after charging or recharging the battery pack, the phone might not work and you
might hear error tones.
•
If you hear the error tones, return the remote keypad to the cradle for at least 5 seconds to reset the security
access-protection code.
•
Recharge the battery pack when the BATT. LOW sound on the remote keypad .
•
If the CHARGE indicator does not light when you place the keypad in the base unit, check the charging
contacts on the remote keypad and base. If the connects are dirty or tarnished, clean them with a pencil
eraser. (See Figure 7)
•
About once a month, fully discharge the battery pack by keeping the remote keypad off the base unit until
the BATT. LOW sound lights. This will maintain the battery pack's ability to fully recharge.

ADJUSTING THE HEADSET

Put on the headset, and adjust the band until it rests with almost no pressure on your ear and the top of your
head. (See Figures 8 and 9)
1. If the headset is too loose, remove it and gently push the headset band inward slightly to tighten it.
If the headset is tight, gently pull the headset band out to loosen it.
2. The microphone boom can be swiveled to position the headset on either your right or left ear.
3. Use one hand to hold the headset in place.
Do not twist the mic on the end of the boom as this may damage the internal wiring.
4. Use the clothing the clip to attach the headset cord to your lapel or collar and out of your way.
5. Leave enough slack in the headset cord so that you can move your head freely.
6.
When you are not using the headset, always place it on the base unit headset holder.
8