Making And Receiving Calls - Plantronics CT10 Owner's Manual

OPERATION
- continued

MAKING AND RECEIVING CALLS

Before using your cordless telephone, put the headset on and adjust it as needed.
1. Set the RINGER switch on the remote keypad to the ON position.
2. To make a call, press the TALK/HANG UP button, the IN-USE indicator will light.
3. When you hear dial tone, enter the number you want to call. (See Figure 11)
FIGURE 11
4. To disconnect a call, press the TALK/HANG UP button..
5. To answer a call when the keypad is not on the base, press the TALK/HANG UP button, the IN USE
indicator will light.
6. To conserve battery power, set the RINGER switch to the OFF position when the remote keypad is away
from the base. When you hear another phone on the same line ring, press the TALK/HANG UP button to
answer the call.
7. When you press a button on the remote keypad, a short tone will be heard indicating that the base unit has
accepted the command.
8. Three tones indicate that you have pressed a button in error, you are out of range, or there is too much
interference.
9.
If there is severe interference, move closer to the base before you press any key.
If interference is severe, the keypad might lose communication with the base and the call might be
disconnected. This does not happen often, but if it does, return the keypad to the cradle for a few seconds.
TALK/HANG UP
Button
10