Advertisement
3.11
Use the seal head tool (01797-07) to tighten
the seal head to the cylinder tube extension.
Tighten to 20 Nm
3.12
Pour 0,5 litre Öhlins Front Fork fuid (01309-xx)
in the fork leg. See setup data and the oil level-
force diagram in this folder.
3.13
Put the preload tube and the spring on top of
the cartridge.
3.14
Fasten the pull-up tool (01765-03) at the top of
the shaft extensioner. Install the spring support
by leading it over the tool.
3.15
Pull up the shaft assembly and use a 19 mm
wrench to grab the spring support.
3.16
Open the compression and the rebound
adjuster fully. Remove the pull-up tool and
install the top cap to the shaft extensioner.
Tighten to 15 Nm
3.17
Pull up the outer tube. Make sure the fork leg is
in a fully extended position.
Use the top cap tool (00797-08) and tighten the
top cap to the outer tube to 10 Nm.
3.18
Set the spring preload, rebound and
compression adjusters according to the setup
data in this manual.
3.11
3.14
3.15
3.16
6
3.12
3.13
Spring
Preload
tube
3.17
Advertisement
