, stand behind all of our products. ® If you are not completely satisfied or have any questions, United States and Canada: Please contact us at: angelcare@cdecinc.ca Other countries: Please contact your local distributor. FCC AND IC REGULATIONS RF radiation exposure statement The Nursery Unit complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
This monitor SHOULD NOT be used incorrectly replaced. The Parent Unit battery is a as a medical device, nor as a device to prevent replaceable Li-Ion battery. Only use the Angelcare Sudden Infant Death Syndrome (SIDS). recommended replacement battery. In both units, 2.
Page 4
Sensor Pad measuring Any mounting of the product should follow the at least 33 x 33 cm and 6 mm thick. Only use manufacturer’s instructions. your Angelcare monitor in a stationary sleeping ® 15.9 Unplug this appliance during lightning storms environment such as a crib where the Sensor or when not used for long periods of time.
that may result in leakage or explosion. harmful interference to radio communications. 16.12 Remove batteries from both units if you store 17.3 H oweve r, th e re is n o g ua ra nte e th at the product over 30 days because the batteries inter ference will not occur in a par ticular could leak and damage the product.
Delivery content Tabletop stand Touch control parent unit Camera (for camera) AC adapter Lithium ion battery pack AC adapter (for parent unit) (for parent unit) (for camera) * Always place printed side up * Wall mount Flat micro USB cable (for camera) (for camera adapter) with hardware...
Camera Setup The camera can be hung on a wall or placed on a flat, stable surface. Consider you will need a suitable wall outlet within reach, be mindful the camera and cord should always be more than 3 feet away from children. Strangulation Hazard: Children have been STRANGLED by cords.
Charging the Parent Unit • Prior to the first use, we recommend that you charge the parent unit for 8 hours. AC410/AC417 • Unlock the battery compartment on the backside and remove the cover. Insert the provided 08/04/2016 rechargeable battery into the compartment. Contacts of the battery and the contacts in the compartment must be aligned.
Navigating the Parent Unit In the top section of your screen you will see a blue bar with all of the necessary information concerning the status of units, alerts, temperature, and your chosen settings. Camera connection Time/T emperature signal strength Active camera Volume level Battery status...
Note: • If the bottom of the crib is not a solid, stable surface you will need to place a hard support board (not included) underneath the sensor pad to ensure correct operation of the system. • Place the sensor pad directly underneath the mattress (and on top of support board, if needed) in the center of the crib.
Designed in Canada. Made in China. While Angelcare intends to provide peace of mind to our consumers, monitoring of a premature baby or babies considered to be at risk should be carried out only under the supervision of a doctor or health care professional. This product is not intended to diagnose, treat, mitigate, cure or prevent any disease or condition. ...
TROUBLESHOOTING TAKING CARE OF YOUR RECHARGEABLE BATTERIES • Ensure that you fully charge your batteries for 8 hours before their first use. • To maintain maximum battery life it is recommended that you fully discharge your batteries periodically. If your Parent Unit is not in use, please turn it OFF. FALSE ALARMS •...
Angelcare video, movement and sound ® accessories which are not Angelcare-branded, or monitor (model AC1300) is free from any material any problems that result from usage that is not in and workmanship defects, for a period of two (2) accordance with product instructions, failure to years from the date of the original purchase.
Need help?
Do you have a question about the AC417 and is the answer not in the manual?
Questions and answers