Table of Contents
Advertisement
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis
2. If you use an AC'97 audio panel, please install it to the front panel audio header by
Chassis Fan / Waterpump
Fan Connector
(4-pin CHA_FAN3/W_
PUMP)
(see p.8, No. 21)
Chassis Fan Connectors
(4-pin CHA_FAN1)
(see p.8, No. 3)
(4-pin CHA_FAN2)
(see p.8, No. 11)
CPU Fan Connector
(4-pin CPU_FAN1)
(see p.8, No. 4)
26
must support HDA to function correctly. Please follow the instructions in our
manual and chassis manual to install your system.
the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don't need to
connect them for the AC'97 audio panel.
E. To activate the front mic, go to the "FrontMic" Tab in the Realtek Control panel
and adjust "Recording Volume".
GND
FAN_VOLTAGE
FAN_SPEED
1
2
3
FAN_SPEED_CONTROL
CHA_FAN_SPEED
FAN_SPEED_CONTROL
CHA_FAN_SPEED
FAN_VOLTAGE
FAN_SPEED_CONTROL
CPU_FAN_SPEED
FAN_VOLTAGE
Please connect fan cables
to the fan connectors and
FAN_SPEED_CONTROL
match the black wire to
the ground pin.
4
4
3
2
1
Please connect fan cables
to the fan connectors and
match the black wire to
the ground pin.
FAN_VOLTAGE
GND
4
3
2
1
GND
This motherboard
provides a 4-Pin CPU fan
GND
(Quiet Fan) connector.
If you plan to connect a
1
2
3
4
3-Pin CPU fan, please
connect it to Pin 1-3.
Hide quick links:
Advertisement
Table of Contents
