Getting Started; Battery Installation - Digger; Battery Notice - VTech Toot-Toot Drivers Construction Site User Manual

GETTING STARTED

BATTERY INSTALLATION – DIGGER
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom of
the digger. Use a screwdriver to loosen
the screw.
3. Install 2 new AAA (AM-4/LR03) batteries following the diagram
inside the battery box. (The use of new alkaline batteries is
recommended for maximum performance.)
4. Replace the battery cover and tighten the screw to secure.

BATTERY NOTICE

• Use new alkaline batteries or fully charged NI-MH (Nickel Metal-
hydride) rechargeable batteries for best performance.
• Alkaline Batteries are recommended.
• Alkaline Batteries are recommended. Rechargeable batteries are
not guaranteed to work with this product.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard
(carbon-zinc) or rechargeable (Ni-Cd, Ni-MH), or new and used
batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
5