Final Preparation - advanced scale models C-130 Hercules Instruction Manual

Step 30.
Important!
Please note that the four engine nacelles are numbered. Take
care when fitting the nacelles to the wing and make sure that
each nacelle is installed in the correct position.
Step 31.
Each nacelle is secured in place by a mounting
bolt through the access holes in the top of the
wing panels.
With the nacelles in place, the plastic fairing can
be fixed in place with some medium CA adhesive.
Step 32.
To fit the wings, slip the wings onto the wing
tube and secure in place with a mounting bolt
(3mm x 40mm) installed through the under-
side of the wing. The rear wing tube is not
screwed in place.

Final Preparation.

Step 33.
The receiver, receiver battery and if fitted, the retract
servo and control valve, are secured to a pre cut plywood
tray which is glued in place between the two central
fuselage formers. Protect the receiver battery and
receiver with some foam padding.
Step 34.
Install the receiver switch in a convenient location on the fuselage.
Under the wing is probably the best area for the switch as it is out
of sight, yet easily accessible. For glow engine powered models,
keep the switch away from the engine exhaust.
Step 35.
Carefully drill some small pilot holes through the front canopy and
into the plywood reinforcing blocks in the front of the fuselage.
Secure with the screws provided.
Step 36.
The black, front nose cone can be fixed permanently in position
with some medium CA adhesive.
Page 8