JVC KW-V340BT Instruction Manual page 40

Settings Settings
<Beep>
• ON (Initial): Activates the key-touch tone.
• OFF: Deactivates the key-touch tone.
<SETUP Memory>
Memorize, recall, or clear the settings you have made.
• The memorized settings are kept even when the unit
is reset.
Touch [Yes] to display the setting screen, then select
an operation:
• Recall: Recalls the memorized settings.
• Memory: Memorizes the current settings.
• Clear: Clears the currently memorized settings.
• Cancel: Cancels.
A confirmation message appears. Touch [Yes].
<DivX(R) VOD>
This unit has its own Registration Code. Once you
have played back a file with the Registration Code
recorded, this unit's Registration Code is overwritten
for copyright protection.
• Touch [Enter] to display the information.
• To return to the previous screen, touch [OK].
<Initialize>
Initialize all settings you have made. Touch and hold
[Enter] to initialize the settings.
• After initializing the settings, adjust the settings on
the <Initial Settings> screen.
36 ENGLISH
<Touch Panel Adjust>
Adjust the touch positions of the buttons on the
screen.
Touch the center of the marks at the upper left (1),
the lower center (2), then the upper right (3) as
instructed.
• To reset the touch position, touch [Reset].
• To cancel the current operation, touch [Cancel].
<System Information>
Update the system by connecting a USB device
containing an update file.
• To obtain the update file, visit
<http://www.jvc.net/cs/car/>.
Connect a USB device with the update file to the unit.
<Application Version>
Updates the system application.
<System Version>
Updates the system.
<DVD Version>
Updates the DVD system application.
The system update starts. It may take a while.
If the update has been completed successfully,
"Update Completed" appears, then reset the unit.
• Do not disconnect the USB device while updating.
• If the update has failed, turn the power off and then
on, and retry the update.
• Even if you have turned off the power during the
update, you can restart the update after the power
is turned on. The update will be performed from the
beginning.
<Open Source Licenses>
Shows the Open Source Licenses.