JVC KW-V340BT Instruction Manual page 34

Settings Settings
<Space Enhancement>*1
Virtually enhances the sound space using the Digital
Signal Processor (DSP) system. Select the enhance
level.
• OFF (Initial)/Small/Medium/Large
<K2>*2
Restores the sound lost due to audio compression to a
realistic sound.
• OFF/ON (Initial)
<Sound Response>
Virtually makes the sound more realistic using the
Digital Signal Processor (DSP) system. Select the sound
level.
• OFF (Initial)/Level 1/Level 2/Level 3
<Sound Lift>
Moves the center of the sound to the lower or higher
point. Select the height.
• OFF (Initial)/Low/Middle/High
*1 You cannot change the setting when "Tuner" is selected as the
source.
*2 This function works only when "DISC"/ "USB"/ "iPod"/
"Android™" is selected as the source.
<Fader/Balance>
Touch [ J ]/[ K ]/[ H ]/[ I ] or drag the
<Fader>
Adjusts the front and rear speaker output balance.
When using a two-speaker system, set the fader to the
center (0).
• F15 to R15 (Initial: 0)
30 ENGLISH
<Balance>
Adjusts the left and right speaker output balance.
• L15 to R15 (Initial: 0)
To clear the adjustment: Touch [Center].
<Speaker/X'over>
Preparation:
Before making the adjustment for <Speaker/X'over>,
select the appropriate crossover network mode
according to the speaker system (2-way speaker
system or 3-way speaker system).
1
Turn off the AV source.
On the Home screen, touch as follows:
2
Display the <X'over Network> screen.
On the monitor panel, press the following buttons
at the same time:
• For KW-V240BT:
• For KW-V340BT:
3
Select the crossover network mode.
[2way]
mark to adjust.
[3way]
A confirmation message appears. Touch [Yes].
and EQ
and
Select this when 2-way system
speakers are used (front/rear).
Select this when 3-way system
speakers are used (tweeter/mid
range/woofer).
Setting the speakers and crossover
frequency
1
Select a car type ( 1 ), select the location
of the speakers ( 2 )*, then display the
<Speaker Select> screen (
* Speaker location selection is available only when
<X'over Network> is set to [2way].
2
Select the speaker type ( 1
of the selected speaker ( 2
the <X'over> screen ( 3 ).
• If a speaker is not connected, select <None>.
• When setting the front speakers, also select the
speaker size for <Tweeter>.
3 ).
), select the size
), then display