Table of Contents
Advertisement
3.3 PTZ Operation
Before starting PTZ control, please make sure the camera you wish to control is a supported PTZ camera and is installed and
configured properly. See section 4.2.6 PTZ for setup information. To enter PTZ mode, follow one of the options below:
1.
Right-click on the screen and select PTZ Control.
2.
Click on the joystick button
3.
Press the PTZ button on the front key.(enable front key model)
4.
Also to use UTC click the
by up/down, left/right button change the setting. Enter is select menu.
In PTZ mode, user can control PTZ operation with the USB mouse.
While pressing the left button of the mouse, drag the mouse pointer up/down, left/right to move pan/tilt position of the camera
accordingly. The further away from the center of the screen you move the mouse, faster will the camera move. The user can
also zoom-in/out by rolling the wheel of mouse up or down.
N
Full PTZ functions are available by using USB mouse, or keyboard controller and are available only on
OTE
supported PTZ cameras.
For focus control in PTZ mode, right-click to get the pop-up menu as shown below. Default mode is to "ZOOM". Select
"FOCUS" to switch the mouse's wheel function from zoom-in/out to focus near/ far.
The user can also select the preset button to start/ stop a preset, or exit PTZ screen model.
N
User will see numeric pad to select "Preset" number. The preset is defined by setting a PTZ protocol in
OTE
in the menu bar located on the bottom of the main screen.
button, the camera menu display on the full screen. And user move button menu
User's Manual | 22
Advertisement
Table of Contents
