Spot Out Monitor - Nitro XHDART User Manual

23 | Full HD Digital Video Recorder
the setting menu. The maximum number of preset is 255, but the number of available presets may vary
by camera make and model.
User can automatically switch PTZ camera positions according to defined presets by using the GUARD TOUR function. The
connected PTZ camera must support touring functions. "GUARD TOUR" on the pop-up menu can be enabled only in full
screen mode. See 4.2.6 PTZ for instructions on how to setup the GUARD TOUR.
C
Depending on PTZ camera, some preset positions might be skipped if, for example, the PTZ camera
AUTION
cannot mechanically move or control focus within the interval time required by the DVR. In this case,
it is recommended to increase the interval setting to a value that allows for the cameras to finish its
Pan & Tilt.

3.4 Spot out Monitor

Click the right button on the mouse and select the Spot out MONITOR in order to enter call monitor control mode. The
numeric panel will pop up at the center of the screen.
Click the specific channel button on the numeric panel to display full screen mode out of assigned spot out channels.
▪ Press the close button on the bottom of the numeric panel. It will go back to the previously programmed spot monitor mode.
N
- A spot out monitor displays another spot out monitor's video in full screen through the function, spot out
OTE
monitor.
- In spot sequence setting mode, if spot out monitor is selected, spot sequence stops and selected
channel pops up.
- While call monitor runs, if a channel event happens, spot out monitor stops and the event pops up.