Releasing The Camera From Computer Control; Releasing The Camera - Polaroid PDC 3000 User Manual

Releasing the camera from computer control

You may wish to release the PDC-3000 camera from
computer control so you can operate it via the controls on the
camera and store pictures in the camera without
disconnecting the camera from the computer.

Releasing the camera

To release the camera from computer control, exit from the
application (PDC Plug-in or PDC Direct) being used to
control the camera.
After releasing the camera, refer to Chapter 3 for camera
operating instructions.
WARNING: DO NOT TURN OFF THE CAMERA OR
DISCONNECT IT FROM THE COMPUTER AFTER IT
HAS BEEN RELEASED FROM COMPUTER CONTROL.
DOING SO COULD DAMAGE YOUR COMPUTER OR
CORRUPT DATA ON YOUR HARD DISK.
If you want to turn off the camera while its cable is
connected to the computer, use the procedure recommended
for any SCSI device: (1) turn off the computer, and (2) turn
off the camera. To disconnect the camera from the computer,
see the PDC-3000 User's Guide.
Using the PDC-3000 with your PowerMac/PowerPC 157