Frigidaire FPIC3677RF Use & Care Manual page 13

To Operate the Bridge Induction Element:
1. Place the correctly sized cookware on the induction
bridge surface element.
2. Push in and turn the control knob as shown in Figure
4 for larger or rectangular shaped cookware. The
"bridge" mark on the knob indicates that both front
and rear portions will heat.
3. Turn the knob to adjust the setting if needed. Start
most cooking operations on a higher setting and
then turn to a lower setting to finish cooking. Each
induction element provides a constant amount
of heat at each setting. Please note that not all
cookware will fit the Bridge element correctly.
4. When cooking has completed, turn the surface
control knob to OFF before removing the cookware.

NOTE
Both left front and rear elements must be OFF before
activating the bridge element. Bridge element will
only operate by using the front left control knob. The
left rear knob cannot be used while in bridge mode.
The cooktop will triple beep and the display will flash
until the left rear knob is turned OFF if the cooktop is
already in bridge mode.
Turning on the front left knob to activate the bridge
element while the left rear element is on will also cause
the cooktop to triple beep and the display will flash
until the left rear knob is turned OFF.
SETTING INDUCTION SURFACE CONTROLS
Figure 4
Front left control knob
Figure 6
Front plus Rear
13