Cleaning Your Hard Floors - Bissell 2078 SERIES User Manual

Cleaning Your Hard Floors

NOTE: Before you clean, thoroughly sweep or vacuum floor prior to cleaning
with your PowerEdge™ Lift-Off® Steam Mop. Your hard floor cleaner is
designed to clean hard flooring, such as ceramic tile, marble, stone and sealed
hard wood floors. Use on waxed or some unwaxed floors may result in a
diminished glossiness. The hard floor cleaner is not for use on unsealed wood
floors. For best results, test in an inconspicuous area and check the care
instructions from your flooring manufacturer.
1
3
When the machine is
plugged in, the READY
light will start to blink.
The READY light will turn
to a solid light when the
machine is ready to use.
6
NOTE: Upon the first use of your steam mop or first use after refilling the
water tank, the pump may make a "knocking" sound. This is normal and will
diminish after a few seconds.
NOTE: The steam mop generates hot steam, so move the unit continuously
when depressing the trigger as damage to flooring can occur. The trigger
does not need to be depressed at all times.
Attach mop pad by
wrapping around bottom
of foot, making sure gray
stitching is located on
the front of foot and the
Quick Grip Release Tab is
located on the back.
4
Step on the back of the
foot to recline the body of
machine to begin cleaning.
To be sure to sanitize an
area of your floor, use
the microfiber cloth pad
and slowly and evenly
stroke your steam mop
back and forth at least
three times over the
area using continuous
steam. For best results,
remove the pad and
wash after use.
2
Plug machine into an outlet.
5
Push the trigger on the
handle to release steam.
7
x2
x2
www.BISSELL.com
For optimum
corner cleaning,
perform two
cleaning strokes
along each wall
towards the corner
to be cleaned.
When done
cleaning, unplug
the machine.
7