Camber And Caster; Rear Spring - Polaris Trailboss 7174820 Owner's Manual

MAINTENANCE AND LUBRICATION

Camber and Caster

The camber and caster are non-adjustable.

Rear Spring

The rear shock absorber spring is
adjusted by rotating the adjuster (1)
either clockwise or counterclockwise to
increase or decrease spring tension.
NOTE: Accessory springs are
available through your
Polaris dealer.
WARNING
Improper adjustment of the handlebars or incorrect torquing of
the adjuster block tightening bolts can cause limited steering or
loosening of the handlebars, resulting in loss of control and
possible serious personal injury or death. Follow the adjustment
procedures exactly, or see your Polaris dealer for service.
Handlebars
The handlebars can be adjusted for
rider preference.
1. Remove the handlebar cover
and locate the handlebar bolts (1).
2. Loosen the four bolts.
3. Adjust the handlebar to the
desired height. Be sure the
handlebars do not contact the
gas tank or any other part of the
machine when turned fully to the left or right.
4. Torque the front two bolts to 10-12 ft. lbs. (14-17 Nm), then
torque the rear two bolts. A gap of up to 1/8" will remain at the
rear bolts.
72
1
1