Table of Contents
Advertisement
18
www.electrolux.com
11.3 Catalysis (Refresh
programme)
CAUTION!
Do not clean the catalytic
surface with oven sprays,
abrasive cleaning agents,
soap or other cleaning
agents. This will damage the
catalytic surface.
Wipe off the bottom of the cavity with a
soft cloth. Remove heavy dirt with normal
cleaning agents or oven spray
commercially available. Make sure to avoid
any contact of the cleaning agent with the
catalytic coated walls and top.
Clean the oven door inner glass with warm
water and a soft cloth.
Remove all accessories and removable
shelf supports.
The walls and the top of the cavity are
catalytic-coated. They absorb fat and dirt
at a big heat without smell.
To support this self-cleaning process heat
the appliance without any food regularly.
Spots or discolouration of the
catalytic surface have no
effect on catalytic properties.
1. Touch
display shows "Cata" and the duration
of the cleaning procedure (1 hour).
You cannot set the Duration, but you
can use the End function to delay the
start of the cleaning procedure.
An acoustic signal sounds after the time
ends. The appliance deactivates.
2. Touch any sensor field to stop the
signal.
3. Clean the bottom of the appliance
with a soft and moist sponge.
To protect the bottom from spoiling, insert
a cake tray while baking below the food.
Do not line the oven with aluminium foil
and do not place baking trays, pots, etc.
on the oven floor, as the heat that builds
up will damage the oven enamel.
again and again until the
11.4 Odour filter
The odour filter reduces the odours which
occur when you bake or grill. It starts to
work if the temperature in the appliance is
more than 120 °C. The odour filter is
placed on the oven ceiling and
regenerates itself.
Activate the odour filter in the
Settings menu.
When the odour filter is on, the display
shows the symbol
The odour filter stops when you deactivate
the appliance or open the oven door.
11.5 Removing and installing the
door
You can remove the door to clean it.
WARNING!
Be careful when you remove
the door from the appliance.
The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A) on
the two door hinges.
A
3. Close the door until it is at an angle of
approximately 45°.
.
A
Advertisement
Table of Contents
