Table of Contents
Advertisement
Chapter 6: Care and Maintenance
Cleaning the Axon Mic
Use a soft, damp cloth to clean the surface of the Axon Mic. Do not use harsh cleaners or
solvents. Do not immerse the Axon Mic in water or cleaning solutions.
Charging the Battery
A fully charged device battery should provide enough power for approximately 12 hours of
normal operation. Recharging a battery after a 12-hour use can take up to 6 hours if you
are recharging your Axon Mic from a wall outlet or Axon Dock. Recharging could take
considerably longer if you are recharging from a computer.
If the battery depletes significantly during use, you will hear 4 quick tones repeating every 5
minutes. This message indicates that less than approximately 20 percent of the battery
capacity remains.
Always recharge a depleted battery as soon as reasonably possible. You can use an Axon
Dock, wall charger, or computer to charge the battery. Using a non-TASER approved wall
charger may degrade device performance and will void the warranty.
If the Axon Mic is to be stored for a long time, the Battery LED should be yellow when you
put the camera in storage. After an Axon Mic has been stored 6 months, the device should
be run until the battery is depleted and then the battery should be recharged.
Replacing the Battery
Replacement batteries are combined with the back portion of an Axon Mic. Replacing a
battery involves removing the back of the device and installing a new back.
1
Turn the Axon Mic off.
2
Using a Torx T6 screwdriver, remove the screws from the Axon Mic.
Page 17 of 22
Advertisement
Table of Contents
