Water Quality Maintenance Start-Up - Master Spas Trainer 12 Owner's Manual

WATER QUALITY MAINTENANCE START-UP

WATER QUALITY MAINTENANCE START-UP
For Eco Pur Water Filter System
™
Step 1:
Your swim spa should be filled using a Pre-filter, which can be obtained from your local
dealer. This Pre-filter will help remove many of the minerals existing in the water,
which will make adjusting the water balance easier after a new fill. Never use more
then 50% softened water when filling the swim spa.
Step 2: During the initial filling of the swim spa, add a sequestering agent to combat sus-
pended minerals in the water. The agents are sold under many different names such as
Mineral Clear, Stain and Scale, Metal Protect, and other brands. Allow water to circu-
late and
filter for at least 12 hours before adding any other chemicals.
Step 3:
Test water for pH, total Alkalinity, and Calcium hardness. The pH should be 7.2 - 7.8
and the total Alkalinity 80-150 PPM. Calcium hardness levels should be maintained
between 150 and 250 PPM (part per million).
Step 4:
Adjust pH and total Alkalinity (TA) utilizing the directions on the chemical bottles.
Wait 15 minutes, test and adjust if necessary.
Step 5:
It may be necessary to retest and add additional chemicals to get to the proper levels
in Step 3.
Step 6:
Add 2 ounces of concentrated chlorinating granules* (sodium Dichlor-s-triazinetreone)
on initial start up to begin sanitizing the swim spa water. Always refer to the chemical
manufactures dosage recommendations listed on the container. It is important not to
add the chlorinating granules until the pH, alkalinity and calcium hardness have been
adjusted to their proper levels.
*SPECIAL NOTE:
We recommend a minimum level of 1.0 ppm residual chlorine be maintained in swim spa water. Always refer to
the chemical manufacturer's dosage recommendations listed on the container.
When adding chlorine or non-chlorine shock/oxidizer always broadcast across the water while the pumps are
running.
The quantities of sanitizer and oxidizer shown in this manual are for 500 gallon swim spas and may have to be
adjusted depending on the actual amount of water that your swim spa holds. See the specifications section of
this manual for the correct gallons of your swim spa.
The concentration of active ingredients in swim spa chemicals varies by manufacturer. Swim spa chemicals are
the same as spa chemicals. The amounts of sanitizer suggested in this manual are based on swim spa chemicals
that have the active ingredient percentages listed below:
Chlorine
Active ingredient:
Sodium dichlor ................................. 99.9%
Other ingredients ................................ 1%
Total ............................................... 100%
DO NOT DIVE.
DO NOT DIVE.
Non-Chlorine Shock/ Oxidizer
Active ingredient:
Potassium peroxymonosulfate ....................... 42.8%
Inert ingredients ............................................ 57.2%
Total............................................................ 100%
24
22