Setup And Adjustments - Sealey SM355CE Instructions Manual

1 Vice handwheel
2 Vice quick lock lever
3 Blade safety guard
4 Blade tension
adjustment wheel
5 Handgrip control
6 Microswitch
7 Blade
8 Fixed blade guide
9 Power lamp
10 Mains power switch
11 Option switch
12 Emergency OFF
13 ON/OFF Switch
14 Auto OFF limit switch
15 Bow damper cylinder
16 Stop bracket
17 Stop rod
18 Coolant pump
19 Lifting hole
20 Bow pivot lock
21 Machine bed fixing
22 Lifting hole
23 Machine bed fixing
24 Access hatch
25 Stand front panel
threaded inserts on either side ( see Fig.3 ) and these should
be aligned with the fixing holes on either side of the lower edge
of the machine bed.
3.3.5 Bolt the machine bed to the stand using the 10mm bolts and
spring washers provided. See 21 and 23 in Fig.4.
3.3.6 Lift the machine and place it in it's intended position. Mark the
floor fixing positions through the holes in the floor fixing points.
See 26 and 27 above.
3.3.7 Lift the machine to one side and drill the floor to take suitable
anchor bolts. Lift the machine back into position and secure it
with the chosen fixings. Note: Floor fixings are not provided.
3.3.8 Stop rod and bracket
3.3.9 Screw the stop rod into the front of the vice as shown above in
Fig.4 - 17. Slide the main bracket (16) onto the stop rod with its
flat surface facing towards the vice. Bolt the adjustable
extension piece into the keyway on the main bracket so that it
is facing towards the vice.
3.3.10 Cleaning off protective coatings
3.3.11 Clean protective oils from the painted and unpainted surfaces
of the machine using a suitable detergent and a dampened
cloth. Thoroughly dry the surfaces afterwards.
3.3.12 Making the electrical connection.
3.3.13 Connect the machine to the mains power supply as described
in Section 1.

4. SETUP AND ADJUSTMENTS

4.1 COOLANT
4.1.1 The use of a water soluable coolant will increase cutting
efficiency and prolong blade life. Five litres of soluable cutting
oil can be ordered under Sealey Part. No. SCO5L (follow
instructions on pack regarding use and precautions).
4.1.2 Coolant is drawn from the coolant tank by the coolant pump
(see Fig.4 - 18) and fed through a clear plastic tube to a valve
situated on the top edge of the bow casting (see 'J' in Fig.9).
When the valve is opened the coolant is fed down two
separate pipes which deliver the coolant directly into each
blade guide. The coolant is then deposited onto the machine
Original Language Version
Fig.4
26 Floor fixing point
27 Floor fixing point
28 Stand end panel
29 Blade direction symbol
30 Adjustable blade guide
SM355CE Issue: 3 - 24/03/10