Operation - Polaris 600 RMK Owner's Manual

Starting the Engine
WARNING
Before starting the engine, always refer to all safety warnings
pertaining to snowmobile operation. Never start your snowmobile
without checking all components to be sure of proper operation.
See Check Before Starting the Engine beginning on page 51.
Starting a Cold Engine
Do not depress the throttle
until the engine starts.
1. Turn the fuel valve on.
See page 28.
2. Turn the key to the ON
position.
3. Pull the engine stop
switch up to the RUN
position.
4. Flip the choke toggle to
FULL ON.
5. Grasp the recoil rope
handle and pull slowly
until the recoil engages;
then pull abruptly.
6. Repeat as needed until the
engine starts.
CAUTION
Don't pull the starter rope to the fully extended position and don't
allow it to snap back into the housing. Damage may result.
To avoid injury and/or engine damage, do not operate the electric
starter or pull-rope starter while the engine is running.
7. After the engine starts, flip the choke toggle to the OFF position.
If the engine slows or wants to stop, use intermittent choking to the
HALF ON position.

OPERATION

CHOKE TOGGLE POSITIONS
HALF ON
OFF
FULL ON
57