Jackshaft Bearing; Driveshaft Bearing; Coupler Greasing - Polaris 600 EDGE Touring Owner's Manual

MAINTENANCE
Lubrication

Jackshaft Bearing

✪
Loosen the driven clutch retaining
bolt and pull the clutch outward to
expose the bearing and grease fit-
✪
ting. Inject grease into the grease
fitting in the flangette until grease
purges from inside or outside the
bearing seal (may take only two
pumps). Push the clutch back onto
the shaft and replace the clutch
retaining bolt. Torque to 18 ft. lbs.
(24.4 Nm).

Driveshaft Bearing

✪
Inject grease into the fitting on the
speedometer sensor housing until
grease purges from the seal on the
inside of the tunnel. This should
take approximately two pumps.
Do not use more than four pumps.

Coupler Greasing

✪
(WideTrak)
Jackshaft
Grease the couplers on
the driveshaft and jack-
shaft.
✪
Driveshaft
87