Page 1
Built - in Gas Hobs Installation and User manual Content Safety instructions---------------------------------- Product description--------------------------------- Gas Conversion Registering your Product Model numbers list : NOT E : This User Instruction Manual contains important information, including safety & installation points , which will enable you to get the most out of your appliance . Please keep it in a safe place so that it is easily available for future reference ;...
Page 2
This manual explains the proper installation and use of your appliance, please read it carefully before using even if you are familiar with the product. The manual should be kept in a safe place for future reference. In case of failure, only the Authorized Technical Service may repair this hob.
Page 3
Safety Instructions and Product Description Tempered glass Trivet Do not use or store flammable materials in the appliance storage drawer or near this appliance. Do not spray aerosols in the vicinity of this appliance while it is in operation. For Universal LPG appliance:- Where this appliance is installed in marine craft or caravans, it shall not Model No .
Page 4
Tempered glass Trivet Tempered glass Trivet Model No . Model No . Wok — Wok Burner Rapid Burner — Wok — Wok Burner SR — SemiRapid Burner Rapid Burner — Aux — Auxiliary Burner SR — SemiRapid Burner Aux — Auxiliary Burner Control knobs Control knobs...
Page 5
The supply connection point, test point and natural gas regulator adjustment screw (for 13.8 Kgs 112x590x510 555 x 475 220- 240V/50Hz GLS4-619GSB1-C2 Natural gas installation) are accessible for testing and/or adjustment with the hotplate in the 16.1 Kgs GLS2-923GSB1 112x870x510 840 x 480 220- 240V/50Hz installed position. 16.4 Kgs GLS3-924GSB1 112x870x510...
Page 6
1. Cupboard Cutting 3. Fit burners and trivet. Bench top thickness, 30– 40 mm ( 3 – 4 cm). Replace burners and ensure they are correctly repositioned over the ignitor ( S) and \ thermocouple ( T). The ignitor ( S) must be clean for trouble free sparking. Test burner ignition and burner flame for correct operation, If burner is placed correctly it will not rotate on its supports..
Page 7
Wiring diagram for Inlet connection region for flexible hose After connecting to gas, check for leaks using soapy solution, never a naked flame. Fit the duplicate data plate ( supplied in separate bag) on a surface adjacent to the hotplate, for example, the inside of the cupboard door so it is clearly visible for any service technician.
Page 8
Auxiliary ( small) and Semi- Rapid ( medium) = 195 mm NA TURAL GAS UNIVERSAL Model Rapid ( large) = 230 mm Injector Injector Test point Test point GLS2-923GSB1 MJ/h MJ/h DCC ( wok) = 300 mm Dia(mm) Dia(mm) 1.8+0.8 17.2 1.02+0.5 17.2...
Page 9
( mm) ) = 80 mm Semi- Rapid ( Rapid ( ) = 195 mm TOUGHENED GLASS PANEL ( e. . ) to mat, TRIVETS (UTENSIL SUPPORTS) BURNERS ( ). item to ( S) ( T). ( S) ( Wok) Gas Conversion (ULPG - NG ) The ULPG to NG conversion kit contains Jet φ0.9mm...
Page 10
Converting to a gas type Converting to a gas type kit. kit. to 1. to 2. Changing the jets Changing the jets kit. kit. Setting the minimum level Setting the minimum level tap to tap to 6. Repeat 6. Repeat Universal LPG Model 2.75kPa...
Page 11
TROUBLESHOOTING Universal LPG Model 2.75kPa Servicing of the hotplates must only be done by an authorised service representative ( see back of this booklet) and the hotplate must not be modified. Power must be disconnected Injector Nominal Gas before any servicing or maintenance is conducted. Burners Dia(mm) Consumption...
Page 12
1.2 Nothing in this warranty affects any person’s rights under the Australian Consumer Law. 1.11 You will be responsible for all costs of returning a Goldline product to the Company and for The benefits to any Consumer under this warranty are in addition to the rights and remedies redelivery of the Goldline product by the Company ( whether it is the original or a repaired and/or available under any Consumer Guarantees.
Need help?
Do you have a question about the GLS2-923GSB1 and is the answer not in the manual?
Questions and answers