Gateway (AT-VGW-250) or it will be unable to sync for control. • The AT-VTP-550 is PoE capable, to power the unit, simply plug it into a 802.3at compatible network switch. If the network switch is not PoE capable, a PoE injector (purchased separately) can be used.
Installation Guide AT-VTP-550 Mounting Instructions The AT-VTP-550 can be mounted to a 1 gang back plate. Select the type of 1 gang back box to use and install into a wall. NOTE: Install using the region’s safety guidelines for electrical boxes.
Installation Guide AT-VTP-550 Installation and Set Up NOTE: Installation of the Velocity Touch Panel can only be done after the VGW-250 has been set up. View the AT-VGW-250 Installation Guide and Velocity Manual for instructions. Connect the Ethernet cable into the back of the unit.
Page 4
Installation Guide AT-VTP-550 Velocity Device Setup Velocity Device Setup Set Static IP Device Alias Velocity Touch Panel 550 IP Address 10.0.0.123 0.0.0.0 Subnet Mask 255.255.255.0 Alt. URL 0.0.0.0 Default Gateway 10.0.0.1 SCAN FOR GATEWAYS DNS Server 75.75.75.75 BACK SAVE & CONTINUE CONTINUE The unit will load a new screen.
Installation Guide AT-VTP-550 On the buildings screen, press the Synchronize button on the building the touch panel is located. When the rooms page opens, press the Synchronize button on the touch panel’s room. Press the SAVE & CONTINUE button on the touch panel.
Page 6
Installation Guide AT-VTP-550 ADVANCED SETTINGS Gateway Settings 0.0.0.0 Alternate URL 0.0.0.0 Device Settings Alias Velocity Touch Panel 550 Touch Screen LAN Configuration Set Static IP IP Address 10.0.0.123 Subnet Mask 255.255.255.0 Default Gateway 10.0.0.1 DNS Server 75.75.75.75 CANCEL SAVE SET PIN...
Installation Guide AT-VTP-550 Connection Diagram I OUT P OUT -250 AT-V AT-VGW-250 (redundancy) I OUT P OUT -250 AT-V AT-VGW-250 AT-VCC-IR Display AV LAN AT-VCC AT-VTP-550-BL AT-VCC-RS232 AT-VCC AT-VTP-800-WH AT-VCC-RELAY Projector AT-VCC Projector Screen AT-VTP-800-BL AT-VCC-IR Display AT-VCC Troubleshooting Problem...