Norcold DE / EV 0061 Installation Manual page 7

Boat refrigerator
Hide thumbs Also See for DE / EV 0061:
Table of Contents

Advertisement

Available languages

Available languages

5. Install the door:
NOTICE
Make sure that the plastic bushings [74] remain in the door hinges.
- Set the lower door hinge onto the lower cabinet hinge and push the door closed until the door latch engages the strike plate.
- Align the holes of the lower door hinge and the lower cabinet hinge.
- Turn the lower hinge pin down through the lower door hinge into the lower cabinet hinge.
- Align the holes of the upper door hinge and the upper cabinet hinge.
- Turn the upper hinge pin up through the upper door hinge into the upper cabinet hinge.
- Make sure that the space between the door and the cabinet is the same all around the door.
- If it is not, loosen the screws that attach the cabinet hinges to the refrigerator and move the cabinet hinges as necessary to
make the space between the door and the cabinet the same all around the door.
- Tighten the screws that attach the cabinet hinges to the refrigerator.
- Make sure that the door latch goes fully into the strike plate.
- If it is not, loosen the screws that attach the strike plate to the refrigerator and move the strike plate as necessary until the door
latch goes fully into the strike plate.
- Tighten the screws that attach the strike plate to the refrigerator.
6. Seal all of the screw holes in the door gasket using a 100% silicone multi-purpose sealant that is safe for food contact:
NOTICE
Read and follow the instructions on the packaging of the silicone sealant.
- Pull the door gasket away from the door.
- Locate the half-moon shaped openings in the door (See Art00985).
- Apply some of the silicone sealant between the door gasket and the plastic door liner and also fill the screw hole opening.
- Push the door gasket back against the door to allow the gasket to seal against the silicone sealant.
- Smooth the silicone sealant in the screw hole opening so it is even with the door cap.
- Remove any excess silicone sealant from the door cap with a dry paper towel.
- Trim off any excess cured silicone sealant.
Installation Manual 7

Advertisement

Table of Contents
loading

This manual is also suitable for:

De / ev 0041Dc 0061

Table of Contents