Dual electric and 12 volt refrigerators norcold non-tek ii (29 pages)
Summary of Contents for Norcold DE-0751S
Page 1
DUAL VOLTAGE REFRIGERATORS 220/240 VOLTS AC AND INSTALLATION AND OWNER’S If service or parts are required, contact the nearest Norcold Service Center. To find an authorized Norcold Service Center near you, please telephone the Norcold Customer Support Dept. at 800-543-1219 (option-1) or visit our web site at www.norcold.com. Norcold Customer Support Dept.
Page 2
Limitations of Warranty 1. This Warranty is the only warranty for a Norcold AC/DC refrigerator. This Warranty does not extend to glassware, electric light bulbs, and replaceable fuses.
If you are not going to use the refrigerator for an extended period of time, put the thermo- stat to the “OFF” position and open the door so the latch pin is in the storage position.
Have an authorized Norcold Service Center check the refrigerator. Cleaning and Defrosting Defrosting It is normal for frost to collect on the freezer plate inside the refrigerator. Excess frost decreases the cooling performance of the refrigerator. Defrost the refrigerator as neces- sary. CAUTION: Do not use sharp objects, a hair dryer, a heat gun, etc.
NOTE: Do not use abrasive cleaners, chemicals, or scouring pads because they can damage the inside of the refrigerator. - Wash the inside of the refrigerator and the door gasket with a solution of liquid dish detergent and warm water.
Art01516) Installation The refrigerator should be located and secured on a solid surface in the vehicle. Before installing the refrigerator into the opening, make sure the DC supply is properly connected. In many cases, the DC supply can be connected from outside the vehicle by means of the baggage or access door.
Be sure the refrigerator is not in direct sunlight or near a gas stove, a heater, or other heat-generating appliances. Avoid installing your refrigerator close to warm water lines or warm air ducts. Your refrigerator was thoroughly cleaned before shipment from the factory.
2. Remove the two (2) bolts that attach the upper hinge. 3. Remove the bolt that attaches the door latch plate to the top of the refrigerator (See Art01513). 4. Remove the upper hinge and the door latch plate from the refrigerator.
Page 9
- Install and tighten the screw that attaches the hinge insert to the door. 7. Put the door onto the refrigerator 8. Install and tighten the two (2) screws that attach the door hinge to the bottom...
Page 10
When using either a converter or a battery charger, make sure that they are connected in parallel between the battery and the refrigerator. Do not use a converter or battery charger to supply the DC power directly to the refrigerator because these two devices do not supply filtered DC power (See Art01521).
Page 11
- Attach the junction cover with the two (2) screws. - Put the two (2) wires through the wire strain relief. - Attach the wire strain relief to the refrigerator cabinet with the self-tapping screw.