Advertisement
How to Initially Charge the battery:
1. Connect the red positive (+) cable to the red positive (+)
pole of the battery.
(see figure 23)
2. Connect the black negative (-) cable to the black
negative (-) pole of the battery. (see figure 24)
Note: The red positive (+) cable has a larger diameter
than the black negative (-) cable.
3. Charging rate: Charge battery @ 0.7 Amps for
5 ~ 10 hours.
• After charging is complete, press down firmly with
both hands to seat the caps. (Do not pound or
hammer.) The battery is now sealed. (see figure 25)
• Locate battery compartment on scooter. The
battery compartment is located under the floorboard.
(see figure 26)
• Attach red positive (+) cable to positive (+) terminal
on battery. Then attach black negative (-) cable to
negative (-) terminal on battery.
•
WARNING
NEVER REMOVE THE STRIP OF CAPS
NOR ADD ANY WATER OR ELECTROLYTE.
Battery Installation
Figure 23
Figure 24
Figure 25
Figure 26
Advertisement
