User Guide 15060-96420100 E13419 E13419_ZE554KL_UM_Booklet_EU_V2.indd 1 2017-08-23 11:40:04...
ASUS Phone (Mobile Phone) Second Edition / August 2017 Model: ASUS_Z01KD (ZE554KL) ASUS_Z01KDA (ZE554KL) ASUS_Z01KS(ZE554KL) Before you start, ensure that you have read all the safety information and operating instructions in this User Guide to prevent injury or damage to your device.
Side features Microphone Volume Key Nano SIM / MicroSD combo card slot Power Key Audio jack Microphone Speaker USB Type-C port NOTE: The USB Type-C port supports USB2.0 transfer rate. E13419_ZE554KL_UM_Booklet_EU_V2.indd 3 2017-08-23 11:40:05...
Rear features Rear cameras Camera flash Rear cover E13419_ZE554KL_UM_Booklet_EU_V2.indd 4 2017-08-23 11:40:06...
Charging your ASUS Phone To charge your ASUS Phone: Connect the USB connector into the power adapter’s USB port. Connect the other end of the USB Type C cable to your ASUS Phone. Plug the power adapter into a wall socket.
Installing a Nano SIM /MicroSD card To install a Nano SIM / MicroSD card: Push a pin into the hole on the Nano SIM / MicroSD card slot to eject the tray out. Insert the Nano SIM or MicroSD card(s) into the card slots.
CAUTION! • Do not use sharp tools or solvent on your device to avoid scratches on it. • Use only a standard Nano SIM card on your ASUS Phone. A trimmed SIM card may not properly fit into and may not be detected by your ASUS Phone. Using NFC NOTE: NFC is only available in selected regions/ countries. You can use NFC in the following three scenarios: Reader mode: Your phone reads information from a contactless card, NFC tag, or other NFC devices.
Card Emulation mode: Your phone can be used like a contactless card. Place the NFC area of your phone on the NFC area of the NFC reader. Peer-to-Peer mode: Transfers photos, contacts, or other data between your phone and an NFC- enabled smartphone.
Federal Communication Commission Interference Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
not be co-located or operating in conjunction with any other antenna or transmitter. • The country code selection is for non-US model only and is not available to all US model. Per FCC regulation, all WiFi product marketed in US must fixed to US operation channels only. RF Exposure Information (SAR) This device meets the government’s requirements for exposure to radio waves.
for this model device with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this model device is on file with the FCC and can be found under the Display Grant section of www.fcc.gov/oet/ ea/fccid after searching on FCC ID: MSQZ01KD. For body worn operation, this device has been tested and meets the FCC RF exposure guidelines for use with an accessory that contains no metal and be positioned a minimum of 1cm from the...
on the phone when using the hearing aid microphone, and a “T” rating that enables the phone to be used with hearing aids operating in the telecoil mode thus reducing unwanted background noise. The Hearing Aid Compatibility rating is displayed on the wireless phone box.
This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter, except tested built-in radios.
requirements are not consistent with the SAR limits and it is advisable to avoid using them. Déclaration relative à l’exposition aux radiations : Le produit est conforme aux limites d’exposition aux fréquences radio pour les appareils portables du Canada établies pour un environnement non contrôlé. Le produit est sûr pour un fonctionnement tel que décrit dans ce manuel.
comply with the e.i.r.p. limits specified for point- to-point and non point-to-point operation as appropriate. the worst-case tilt angle(s) necessary to remain compliant with the e.i.r.p. elevation mask requirement set forth in Section 6.2.2(3) shall be clearly indicated. Users should also be advised that high-power radars are allocated as primary users (i.e. priority users) of the bands 5250-5350 MHz and 5650-5850 MHz and that these radars could cause interference and/or damage to...
Simplified EU Declaration of Conformity Hereby, ASUSTek Computer Inc. declares that the radio equipment ASUS_Z01KD/ ASUS_Z01KDA/ ASUS_Z01KS is in compliance with Directive 2014/53/EU. Full text of EU declaration of conformity is available at https://www.asus.com/support/. (Search for ZE554KL) RF Output Table For ASUS_Z01KDA (ZE554KL), TW-3CA SKU Items Maximum Radio-Frequency Output Power Table Bluetooth RF (2400~2483.5 MHz)
RF Output Table (continued) For ASUS_Z01KDA (ZE554KL), TW-3CA SKU Items Maximum Radio-Frequency Output Power Table LTE Band I (1920~1980; 2110~2170 23 dBm MHz) LTE Band III (1710~1785; 1805~1880 21 dBm MHz) LTE Band VII (2500~2570; 2620~2690 21 dBm MHz) LTE Band VIII (880~915; 925~960 MHz) 23 dBm LTE Band XVIII (815~830;...
RF Output Table (continued) For ASUS_Z01KD (ZE554KL), TW-2CA SKU Items Maximum Radio-Frequency Output Power Table GSM 900 Burst (880~915; 925~960 MHz) 33 dBm GSM 1800 Burst (1710~1785; 1805~1880 30 dBm MHz) WCDMA Band I (1920~1980; 2110~2170 22 dBm MHz) WCDMA Band III ( 1710~1785; 1805~1880 24 dBm WCDMA MHz)
RF Output Table (continued) For ASUS_Z01KD (ZE554KL), WW-2CA SKU Items Maximum Radio-Frequency Output Power Table GSM 900 Burst (880~915; 925~960 33 dBm MHz) GSM 1800 Burst (1710~1785; 29 dBm 1805~1880 MHz) WCDMA Band I (1920~1980; 23 dBm 2110~2170 MHz) WCDMA WCDMA Band VIII (880~915;...
RF Output Table (continued) For ASUS_Z01KS(ZE554KL), and ASUS_Z01KDA (ZE554KL), Operator SKU Items Maximum Radio-Frequency Output Power Table GSM 900 Burst (880~915; 925~960 33 dBm MHz) GSM 1800 Burst (1710~1785; 30 dBm 1805~1880 MHz) WCDMA Band I (1920~1980; 24 dBm 2110~2170 MHz) WCDMA WCDMA Band VIII (880~915;...
RF Exposure Information This ASUS product has been tested and meets applicable European SAR limits. The SAR limit is 2.0 W/kg in countries that set the limit averaged over 10 grams of tissue. The specific maximum SAR values for this device are as follows: For ASUS_Z01KD (ZE554KL) & ASUS_Z01KDA (ZE554KL), TW-2CA &...
Using GPS (Global Positioning System) on your ASUS Phone To use the GPS positioning feature on your ASUS Phone: • Ensure that your device is connected to the Internet before using Google Map or any GPS-enabled apps. • For first-time use of a GPS-enabled app on your device, ensure that you are outdoors to get the best positioning data.
35 °C (95 °F). The battery WARNING: Disassembling the battery by yourself will void its warranty and may cause serious harm. Your ASUS Phone is equipped with a high performance non-detachable Li-polymer battery. Observe the maintenance guidelines for a longer battery life.
Phone. • Never pull the charger cord to disconnect it from the power socket. Pull the charger itself. Caution Your ASUS Phone is a high quality piece of equipment. Before operating, read all instructions and cautionary markings on the (1) AC Adapter. • Do not use the ASUS Phone in an extreme environment where high temperature or high humidity exists. The ASUS Phone performs...
This product complies with the “India E-Waste (Management) Rules, 2016” and prohibits use of lead, mercury, hexavalent chromium, polybrominated biphenyls (PBBs) and polybrominated diphenyl ethers (PBDEs) in concentrations exceeding 0.1% by weight in homogenous materials and 0.01 % by weight in homogenous materials for cadmium, except for the exemptions listed in Schedule II of the Rule. Regional notice for Singapore This ASUS Phone complies with IMDA Standards. E13419_ZE554KL_UM_Booklet_EU_V2.indd 25 2017-08-23 11:40:10...
ASUS Recycling/Takeback Services ASUS recycling and takeback programs come from our commitment to the highest standards for protecting our environment. We believe in providing solutions for you to be able to responsibly recycle our products, batteries, other components as well as the packaging materials.