Table of Contents
Advertisement
right page (11)
of AX76, FCC, LAM-en, (19.08.2005, 12:24)
Getting started
Using the SIM card/battery
Your phone's display is delivered with a
protective film. Remove this film before get-
ting started. The service provider supplies
you with a SIM card on which all the im-
portant data for your account is stored. If
the SIM card is credit card-sized, snap out
the smaller segment and trim any rough
edges.
Press depression
cover downwards in the direction of the
2
arrow
.
Insert SIM card
the locating slot (make sure the angled
corner is in the correct position
To remove the SIM card push the card
5
here
.
1
to remove the
1
2
3
and push it fully into
4
).
5
3
4
Getting started
Insert the battery sideways into the phone
6
, then press downwards
engages.
7
6
To remove, press the retaining tab
then lift the battery out.
Place cover on phone and push to the up-
per edge, until it clicks into place
9
Always switch off phone before removing
the battery!
Only 3V and 1.8V SIM cards are support-
ed. Please contact your service provider if
you have an older card.
Charge battery
The battery is not fully charged when de-
livered. Plug charger cable into the bot-
tom of the phone, plug power supply unit
into a mains power socket and charge for
at least two hours. The power supply unit
heats up when used for long periods. This
is normal and not dangerous.
11
7
until it
8
8
9
.
Advertisement
Table of Contents
