Compliance With Fcc Regulations; Protect Your Furniture - Jensen JSB-550 User Manual

Alexa enabled bluetooh/wifi wireless stereo smart speaker
Table of Contents

Advertisement

IMPORTANT NOTES
Avoid installing the unit in locations described below:
 Places exposed to direct sunlight or close to heat radiating appliances such as
electric heaters.
 Places subject to constant vibration.
 Dusty, humid or moist places.
 Sources of electrical noise such as fluorescent lamps or motors.
 In case of malfunction due to electrostatic discharge, the apparatus has to be reset by
disconnecting it from mains supply, wait at least for 60 seconds before reconnect
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
this device may not cause harmful interference, and
(1)
this device must accept any interference received, including interference that may
(2)
cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
This product is equipped with non-skid rubber 'feet' to prevent the product from moving when
you operate the controls. These 'feet' are made from non-migrating rubber material specially
formulated to avoid leaving any marks or stains on your furniture. However certain types of oil
based furniture polishes, wood preservatives, or cleaning sprays may cause the rubber 'feet'
to soften, and leave marks or a rubber residue on the furniture. To prevent any damage to
your furniture we strongly recommend that you purchase small self-adhesive felt pads,
available at hardware stores and home improvement centers everywhere, and apply these
pads to the bottom of the rubber 'feet' before you place the product on fine wooden furniture.

COMPLIANCE WITH FCC REGULATIONS

FCC ID: LMZ-31324GC

PROTECT YOUR FURNITURE

E2

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents