JVC RS-WP1WT Service Manual page 13

Removing the CD servo board
Prior to performing the following procedure, remove
the CD servo assembly.
1. Remove the four screws S retaining the CD servo
board.
2. Unsolder FW616 where the wire extending from the
OPEN / CLOSE switch board is soldered.
Removing the OPEN / CLOSE switch
board (See Fig.27)
Prior to performing the following procedure, remove
the CD mechanism cover.
1. Remove the screw T retaining the OPEN / CLOSE
switch board.
2. Unsolder FW626 where the wire extending from the
CD mechanism board is soldered.
<Front assembly>
Removing the speaker assembly (R) and
(L) (See Fig.28)
Prior to performing the following procedure, remove
the front assembly.
1. Remove the four screws U attaching the speaker
assembly (R).
2. Remove the four screws V attaching the speaker
assembly (L).
3. Remove the screw W attaching the speaker terminal.
If necessary, disconnect the wire from each speaker
terminal.
Removing the sub speaker assembly (R)
and (L) (See Fig.28)
Prior to performing the following procedure, remove
the front assembly.
1. Remove the four screws X attaching the sub speaker
assembly (R).
2. Remove the four screws Y attaching the sub speaker
assembly (L).
If necessary, disconnect the wire from each speaker
terminal.
(See Fig.27)
OPEN / CLOSE
switch board
Sub speaker assembly (R)
X
W
Speaker
terminal
U
Speaker assembly (R)
FW616
S
FW626
T
S
CD mechanism board
Fig.27
Sub speaker assembly (L)
X Y
U V
Fig.28
RS-WP1WT
S
S
Y
V
Speaker assembly (L)
1-13