Test Mode; Entering Test Mode - Motorola ASTRO XTS 3000 Service Manual

Test Mode

6.2 Test Mode
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
This section describes test mode functionality.

6.2.1 Entering Test Mode

Follow the procedure below to enter test mode.
Procedure 6-1 Entering Test Mode
1
2
3
4
5
6
The table below describes front panel access test mode displays.
Table 6-2 Front Panel Access Test Mode Displays
Name of Display
"SERVICE"
Radio Host Software Version
DSP Software Version
EMC Secure Version
6-2
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
Turn the radio on.
Within 10 seconds after the self test is complete, press Side Button 3 five times
in succession.
The radio will show a series of displays that will give information regarding various
version numbers and subscriber specific information. The displays are described by
the following table, "Front Panel Access Test Mode Displays"
Press Side Button 1 to stop the displays and put the radio into the Control Top and
Keypad test mode. The test mode menuCH TEST is displayed. Go to the "Control
Top and Keypad Test Mode" section.
Each press of the Side Button 1 will toggle between CH TEST and
RF TEST.
OR
Press the Top Programmable Button (Emergency button) to stop the displays and
put the radio into the RF test mode. The test mode menu 1 CSQ will be displayed,
indicating test frequency 1, Carrier SQelch mode. Go to the RF Test Mode section.
The literal string indicates the radio has entered
test mode.
The version of radio firmware is displayed.
The version of firmware being used by the
DSP.
Version of the encryption hardware.
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
Description
Chapter 6: Performance Checks
■ ■ ■
■
■
(Table 6-2).
Appears
Always
Always
Always
When the
radio is secure
equipped.
68P81083C85-A March 2004