Advertisement
32
www.electrolux.com
The inlet hose must not be
lengthened. If it is too short and
you do not wish to move the tap,
you will have to purchase a new,
longer hose specially designed for
this type of use.
11.4 Water Drainage
The end of the drain hose can be
positioned in three ways:
Hooked over the edge of a sink
using the plastic hose guide
supplied with the machine.
In this case, make sure the end
cannot come unhooked when
the machine is emptying.
This could be done by tying it to
the tap with a piece of string or
attaching it to the wall.
In a sink drain pipe branch. This
branch must be above the trap
so that the bend is at least 60 cm
above the ground.
Directly into a drain pipe at a
height of no less than 60 cm
and no more than 90 cm. The
end of the drain hose must
always be ventilated, i.e. the
inside diameter of the drain pipe
must be larger than the outside
diameter of the drain hose.
The drain hose must not be
kinked. Run it along the floor, only
the part near the drainage point
must be raised.
For correct functioning of the
machine the drain hose must
remain hooked on the proper
support piece situated on the top
part of back side of the appliance.
11.5 Electrical Connection
This machine is designed to
operate on a 220-240 V, single-
phase, 50 Hz supply.
Please check rated power
supply condition that is
mentioned on the Rating
Label before you connect
to the power supply.
"An incorrect power
supply may void your
warranty."
Check that your domestic electrical
installation can take the maximum
load required (2.0 kW), also taking
into account any other appliances
in use.
Connect the machine to
an earthed socket outlet.
The manufacturer declines any
responsibility for damage or injury
through failure to comply with the
above safety precaution.
If the supply cord is
damaged, should the
appliance power supply
cable need to be replaced,
this shall be carried out by
our Service Centre.
Advertisement
