Table 40 Fitting The Turbocharger, Di- Mensions X,L; Table 41 Tightening Torque (51007) - ABB A155-M57 Operation Manual

Operation Manual / 4 Product description / A150-M.. - A155-M..
8 Dismantling and fitting
Figure 44: Installing the cartridge group 2
Product
A150
A155
Table 40: Fitting the turbocharger, dimensions X,L
Part number
51007
Table 41: Tightening torque (51007)
1. Lightly lubricate the hole in the bracket, into which the centering bush (42193) is inserted,
with screw grease.
2. If present: Insert the metal C-ring (51105).
3. Move the cartridge group into the turbine casing and align with the markings (M) made on
the bracket at the time of disassembly.
4. Rotate the clamping nut (42201) upwards up to the end of the threaded rod and insert the
centering bush (42193) into the hole.
Check dimension X (if dimension X is not reached, the turbocharger must be realigned).
5. Screw in the threaded rod until value L is reached.
6. Tighten the pressure screws of the clamping nut. (see Tightening pressure screws [➙ 19])
7. Secure fastening strips (51002) together with nuts (51007) and Verbus Ripp® washers
(51003).
© Copyright 2017 ABB. All rights reserved.
Dimension X
112 ±2 mm
144 ±2 mm
A150
M16
175 Nm
HZTL4032_EN
Page 88 / 120
Dimension L
52 ±2 mm
72 ±2 mm
A155
M16
175 Nm
Revision F January 2017