Passive Test Program - Whirlpool 6ADP905/3 WH Service Manual

WHIRLPOOL CONSUMER SERVICES
PS1 PS2 PS3 PS4
Failure
NTC failure
Water leakage
Heating system
Drain system
Spray arm Blocked
Water inlet closed
Flow meter
Water level
Continuous water fill
Rinse aid low
NOTE: The machine will not store Fault Code F6 located during normal operation, only
during the active test. Therefore the active test MUST be run for the
diagnostics to locate this fault. All Other Fault codes located during normal
operation are stored by the machine and will be displayed by the passive test.

PASSIVE TEST PROGRAM

Start
PS1 - PS4
Flash sequentially
Chosen program
LED lights
Finish passive test
program by starting
active test program
Failure No. Indication
F1 Start LED flashes
F2 Start LED flashes
F3 Start LED flashes
F4 Start LED flashes
F5 Start LED flashes
F6 Start LED flashes
F7 Start LED flashes
F8 Start LED flashes
F9 Start LED flashes
Red LED on
Passive test program will indicate the mode of
failure. If there is no failure, the test program
will result in PS1 to PS4 flashing sequentially.
Starting the Passive Test Program
1. Turn the program selector to the off
("O") position
2. Push and hold the start button while
turning the program selector to
first cycle (rinse) until the START LED
begins to flash.
3. Release the start button.
4. The LED's, PS1 to PS4, will now
flash in sequence or light to indicate the
mode of failure of the dishwasher.
5. Repair failure
6. Reset program by pressing start button
for more than 3 seconds
7. Start passive test again and progress to
active
for less than
Models 6ADP905/3 WH
Wash Program Indicators
Rinse
Program Selector
Test Program Indication
PS1 LED Flashes
PS2 LED Flashes
PS3 LED Flashes
PS4 LED Flashes
PS1 & PS4 Flash
PS2 & PS4 LED's Flash
PS3 & PS4 LED's Flash
PS2 & PS3 LED's Flash
PS1 & PS3 LED's Flash
Red LED on
test by pressing the start button
3 seconds
Page 14 of 19
Start