JVC KS-FX621 Service Manual page 16

KS-FX621
2.2.22 Removing the main motor assembly / sub motor assembly
(See Fig.40 to 42)
(1) Remove the belt at the bottom.
(2) Remove the polywasher and pull out the mode gear.
(3) Pull out the reduction gear (B).
(4) Remove the polywasher and pull out the reduction gear
(A).
(5) Remove the two screws D attaching the main motor as-
sembly.
(6) Remove the two screws E attaching the sub motor assem-
bly.
(7) Unsolder the wires on the reel board if necessary.
CAUTION:
When reassembling, adjust the length of the wires extending
from the sub motor asswmbly by attaching them to the side of
the sub motor assembly with the wires extending from the
main motor assembly using a spacer.
1-16 (No.49825)
Reduction gear (B)
Belt
Polywasher
Fig.40
Reduction gear (B)
E
Spacer
Sub motor assembly
Fig.41
Main motor assembly
Sub motor assembly
Fig.42
Main motor
D
assembly
Reduction
gear (A)
Polywasher
Sub motor
assembly
E
Mode gear
Polywasher
Reduction gear (A)
D
Main motor assembly
Spacer