Table of Contents
Advertisement
[ NOTE ]
• Be sure to open the choke when the initial explosion is heard.
• When the choke is opened, be sure to close the throttle valve to a position near the idle
position before starting the next flipping (If the engine is started while the throttle is wide
open, a great thrusting force is produced, which is very dangerous).
• Be sure to wear a thick glove when flipping the propeller. Use all fingers, except thumb,
for the flipping operation.
How to Stop the Engine
For stopping the engine, the black lead wire
from the coil should be grounded to the
engine body, or the throttle valve should be
closed completely.
6. Carburetor Adjustment
The carburetor is provided with 3 adjust screws which are set to the best (approximately)
positions by our company, but they may need a little adjustment depending on the
temperature, atmospheric pressure (altitude), etc. of the area where the engine is used. Start
the engine without making any adjustments. Make readjustments only when the engine
shows any mal-functioning.
Low Speed
Needle
Idle Screw
[ NOTE ]
Be sure to stop the engine before starting the adjustment, thus ensuring safety.
Idle Screw: Turning this screw clockwise increases the idling R.P.M. Turning it
counterclockwise decreases the idling R.P.M.
Low Speed Needle: This is the fuel adjust screw (not the air screw). Turning this needle
clockwise makes the mixture gas leaner and turning it counterclockwise
makes it richer.
High Speed Needle: Turning this needle clockwise makes the mixture gas leaner and
turning it counterclockwise richer. Set this needle at a position which is 1/4
open from the maximum R.P.M. position while the airplane is on ground.
[ NOTE ]
1. Do not tighten the High and Low Speed needles too firmly.
2. When the unit has just started and the engine is not warm enough, there may be
insufficient acceleration and the engine may be stopped. Be sure to perform idling before
operation.
7. Engine Break-in
No specific break-in is required. The engine is gradually getting break-in as it is used and the
output is also increased gradually.
8. Maintenance
This engine is used for power source for radio controlled airplane so you are strictly
requested to check engine and relative parts of airplane.
4
RED LEAD
High Speed
Standard Opening Position :
Needle
LOW SPEED NEEDLE : 1
HIGH SPEED NEEDLE : 1
BLACK
KILL
LEAD
SWITCH
ENGINE BODY EARTH
1
1
/
±
/
2
4
1
1
/
±
/
4
4
Advertisement
Table of Contents
