Advertisement
Warning
To prevent damage to the product or injury to you or to others, read the
following warnings in their entirety before using this product. Keep these
Warnings where users can read them for ready reference.
Do not disassemble or modify. Should the product break down, send the
defective back to the authorized service center for inspection and maintenance.
Keep dry. Do not handle with wet hands, immerse in water, or expose to rain.
Keep out of reach of children.
Please put the device in a ventilation environment and keep the parts of lighting
and heat dissipation holes are unobstructed. Do not use in flammable
environment.
As this product adopts make and break device, please keep it easy to be used.
No touching the heating parts of this product.
Please turn off the power and wear insulated gloves before installing and
connecting accessories. When replacing the tube or modeling lamp, please
make sure that the tube is cool and wear insulated gloves to prevent burns.
Do not flash directly towards naked eyes (especially those of babies), otherwise
it may lead to visual impairment.
Disconnect from the power supply when it will not be used for an extended
period.
CAUTION
After 30 continuous flashes at full power, the flash should be cooled down for
about 3 minutes. Overheating will occur if it is used continuously without cooling
down.
Do not keep using the modeling lamp for a long time; otherwise flammable
accessories attaching to flash head, e.g. softbox will get burnt. A 10-minute time
is recommended in this case. After 10 minutes, cool it down for 1 minute.
When using a snoot, do not keep the modeling lamp on for a long time or fire too
frequently (not over six times for one minute). Overheating will result in damages
for strobe housing and/or studio light.
Avoid sudden impacts as this can damage the flash tube and/or modeling lamp.
- 09 -
NAMES OF PARTS
Body
09
06
10
05
11
12
13
18
02
01
19
01.
AC Power Socket
12.
02.
Sync Cord Jack
13.
03.
Power Switch
14.
04.
Flash Output Controller
15.
05.
Slave Model Button
16.
06.
Modeling Lamp Button
17.
07.
Sound Button
18.
08.
Test Button
19.
09.
Digital Display
20.
10.
S1 Optic Slave Indicator
21.
11.
S2 Optic Slave Indicator
Accessories
1. Power Cord
2. Lamp Cover
3. Modeling Lamp
4. Instruction Manual
1
16
04
07
08
15
14
03
17
20
21
Modeling Lamp Indicator (AUTO mode)
Modeling Lamp Indicator (DIM mode)
Buzz Indicator
Test Indicator Lamp
Light Sensor
Fuse
Wireless Control Port
Mounting Bracket
Umbrella Input
Direction Adjusting Handle
2
3
- 10 -
Advertisement
