Mazda 3 2018 Smart Start Manual page 49

Outside
Thermometer -
Units can be set
to °C or °F using
the Infotainment
System Settings.
TPMS NOTE:
to change and turn the TPMS warning light on. If the warning light comes on, check the
tire pressure and fill the tires as soon as possible, preferably before moving the vehicle
and warming up the tires. Tire pressure should be checked when the tires are cold.
Automatic Transaxle Warning
Lights ON (Exterior) (p. 34)
Blind Spot Monitoring (BSM) OFF
(p. 32)
Seat Belt Unbuckled/Malfunction
Headlight High Beams ON
Electric Parking Brake
Brake Warning
Parking brake on/
low brake fluid/malfunction
Charging System Malfunction
See your Owner's Manual for more details and explanations.
1 Rotate the knob to adjust the brightness of the instrument cluster and other dashboard illuminations.
2 Push to toggle between trip meter (A & B). When a trip meter is selected, push and hold to reset to zero.
ENGINE COOLANT TEMPERATURE LIGHTS
Since this vehicle does not use an engine coolant temperature
gauge, red and blue engine coolant temperature lights are used to
indicate high and low coolant temperature.
Red Coolant Temperature
FLASHING: Engine is starting to
run hot. Drive slowly to reduce
engine load.
ON: Engine is overheating.
Safely pull over to the side of
the road and turn the engine off.
Refer to the Owner's Manual for
more information.
Low ambient temperature and/or high altitude may cause tire pressures
Blue Coolant Temperature
ON: Engine coolant is cold and
no warm air is available for
heater/defroster.
OFF: Engine coolant is warm and
warm air is available for heater/
defroster. The light may stay on
for a few minutes after start-up
when the engine is cold, but the
vehicle can be driven with the
light on or off.
Door Ajar
Liftgate Ajar
Low Washer Fluid Level
Anti-lock Brake System
(ABS) Malfunction
Low Fuel Level
Check Fuel Cap
Perform Maintenance
SPORT Mode ON
Brake Pedal Operation Demand
m{zd{
47
3