Message Codes; Care - Leica DISTO S910 Manual

Functions
Distance measuring yes
Min/Max measuring yes
Permanent measuring yes
Stake-out yes
Addition/Subtraction yes
Area yes
Triangle area yes
Volume yes
Trapezium yes
Painter function (area with partial yes
measurem.)
Pythagoras 2-point, 3-point
Smart Horizontal Mode / yes
Indirect height
Height-profile measurement yes
Level yes
Sloped objects yes
Height tracking yes
Memory yes
Beep yes
Illuminated colour display yes
Pointfinder (Viewscreen) 4x zoom, OV
®
Bluetooth Smart yes
Personalized Favorites yes
Timer yes
Calculator yes
Photo/Screenshot yes
Compass yes
Gallery with USB download yes
Diameter yes
Width yes
Area from Photo yes
Smart Base yes
Pointdata transmission yes
Point to point function /distance yes
Smart Angle yes
Smart Area yes
DXF Data capture yes
Leica DISTO TM S910 805080

Message Codes

If the message Error does not disappear
after switching on the device repeatedly,
contact the dealer.
If the message InFo appears with a number,
press the Clear button and observe the
following instructions:
No. Cause Correction
156 Transverse tilt Hold the instrument without
greater than 10° any transverse tilt.
162 Calibration mistake Make sure, the device is
placed on a absolutely hori-
zontal and flat surface.
Repeat the calibration
procedure. If the mistake still
occurs, contact your dealer.
204 Calculation error Perform measurement again.
240 Data transfer error Repeat procedure.
252 Temperature too Let device cool down.
high
253 Temperature too Warm device up.
low
255 Received signal too Change target surface (e.g.
weak, measuring white paper).
time too long
256 Received signal too Change target surface (e.g.
high white paper).
No. Cause Correction
258 Measurement outside Correct range.
of measuring range
260 Laser beam inter- Repeat measurement.
rupted
300 Smart Base not folded Fold out Smart Base
out
301 Device was moved, Proceed leveling again
leveling not valid any
more
302 «Point data transmis- Switch on WiFi
sion» is selected, but
WiFi is off
340 WiFi: Data transfer Repeat procedure
error
341 Authentication Error Use correct password

Care

• Clean the device with a damp, soft cloth.
• Never immerse the device in water.
• Never use aggressive cleaning agents or
solvents.
EN
45