Bosch GOP 12V-28 Professional Original Instructions Manual page 7

OBJ_BUCH-3037-001.book Page 7 Tuesday, January 17, 2017 3:05 PM
18 Vacuum connection*
19 Extraction adapter*
20 Vacuum hose*
*Accessories shown or described are not part of the standard de-
livery scope of the product. A complete overview of accessories
can be found in our accessories program.
Technical Data
Cordless Multi-Cutter
Article number
Rated voltage
No-load speed n
0
Oscillation angle, left/right
Weight according to
1)
EPTA-Procedure 01:2014
Permitted ambient temperature
– during charging
2)
– during operation and during
storage
Recommended batteries
Recommended chargers
1) depending on the battery pack being used
2) limited performance at temperatures <0 °C
Technical data determined with battery from delivery scope.
Assembly
Battery Charging
 Use only the chargers listed in the technical data. Only
these chargers are matched to the lithium-ion battery of
your power tool.
Note: The battery supplied is partially charged. To ensure full
capacity of the battery, completely charge the battery in the
battery charger before using your power tool for the first time.
The lithium-ion battery can be charged at any time without
reducing its service life. Interrupting the charging procedure
does not damage the battery.
Bosch Power Tools
Removing the battery
To remove the battery 3, press the unlocking buttons 2 and
pull the battery out of the machine to the rear. Do not exert
any force.
Battery Charge-control Indication
The three green LEDs of the battery charge-control indicator
6 show the charging status of the battery 3. The battery
charge-control indicator only illuminates for 5 seconds after
GOP 12V-28
start-up.
3 601 HB5 0..
LED
V= 12
Continuous lighting 3 x green
-1
min 5000–20000
Continuous lighting 2 x green
° 1.4
Continuous lighting 1 x green
Flashing light 1 x green
kg 0.97–1.2
Flashing light 3 x green
When no LED lights up after switching on, then the battery is
°C 0...+45
defective and must be replaced.
°C –20...+50
Changing the Tool
GBA 10,8V...
 Before any work on the machine itself (e. g. mainte-
GBA 12V...
nance, tool change, etc.) as well as during transport
GBA 12V... W
and storage, remove the battery from the power tool.
GAL 11.. CV
There is danger of injury when unintentionally actuating
GAL 12.. CV
the On/Off switch.
GAL 18... W
 Wear protective gloves when changing application
tools/accessories. Contact with the application tool/
accessory can lead to injuries.
Selecting the Application Tool/Accessory
Accessory
English | 7
Capacity
≥2/3
≥1/3
<1/3
Reserve
Empty
GOP 12V-28
1 609 92A 2TY | (17.1.17)