Ctrl-Z, Ctrl-C And Exit; Login From Console Port; Virtual Terminal Access; Password. - Planet ERT-805 User Manual

Serial wan router

Hide thumbs Also See for ERT-805:

Table of Contents

clockrate 48000

ERT_805(config-serial0/0)#

3.4 Ctrl-Z, Ctrl-C and exit

To exit from the configuration mode directly to privilege mode, you should type Ctrl-Z or Ctrl-C

or type exit. Ctrl-C can be available in other occasions .For example it can stop the current

operation that hasn't been accomplished.

Once the terminal has connected to the device, power on the device, the terminal will display

that it is running POST (Power on self-test) procedures.

Then, screen as below will show up. The ERT-805 will prompt with ">". This means ERT-805 is

in operating mode now.

Types "enable" to enter privilege mode. The ERT-805 will prompt with "#" for privilege mode.

By default there is no password.

Router Software Version 4.2c on Hex_1f73 (3805a)

User Access Verification

Password:

ERT_805> enable

Password:

ERT_805#

The router allows being accessed from network by telnet, therefore you could configure and

maintain the router by network. Please to note, if the router hasn't set a password for entering

privilege mode, the router will forbid the network users from entering privilege mode.

ERT805> enable

% Password is not set, you are not allowed to enter privileged mode.

Before login ERT-805 by telnet you must set the password by command "enable password" in

global configuration mode. After that router will allow you're entering the privilege mode by

Table of Contents