Installation Warnings - Projoy Prosol-M600 User Manual

2.2 INSTALLATION WARNINGS

The M300 Micro-inverter is designed and tested according to international safety
requirements(IEC62109-1/-2, VDE4105, VDE0126, AS 4777.1 /.2& AS 3000). However,
certain safety precautions must be taken when installing and operating this inverter. The
installer must read and follow all instructions, cautions and warnings in this installation
manual













6
All operations including transport, installation, start-up and maintenance,
must be carried out by qualified, trained personnel.
Before installation, check the unit to ensure absence of any transport or
handling damage, which could affect insulation integrity or safety
clearances. Choose installation location carefully and adhere to specified
cooling requirements. Unauthorized removal of necessary protections,
improper use, incorrect installation and operation may lead to serious
safety and shock hazards or equipment damage.
Before connecting the Micro-inverter to the power distribution grid,
contact the local power distribution grid company to get appropriate
approvals. This connection must be made only by qualified technical
personnel .It is the responsibility of the installer to provide external
disconnects witches and Over current Protection Devices (OCPD).
Only one photovoltaic module can be connected in the input of the
inverter. Do not connect batteries or other sources of power supply. The
inverter can be used only if all the technical characteristics are observed
and applied.
Do not install the equipment in adverse environment conditions such as
flammable, explosive, corrosive, extreme high or low temperature, and
humid. Do not use the equipment when the safety devices do not work or
disabled.
Use personal protective equipment, including gloves and eye protection
when working.
Inform the manufacturer about non-standard installation conditions.
Do not use the equipment if any operating anomalies are found. Avoid
temporary repairs.
All repairs should be carried out using only qualified spare parts, which
must be installed in accordance with their intended use and by a licensed
contractor or authorized Projoy service representative.
Liabilities arising from commercial components are delegated to their
respective manufacturers.
Anytime the inverter has been disconnected from the power network, use
extreme caution as some components can retain charge sufficient to
create a shock hazard. Prior to touching any part of the inverter use care
to ensure surfaces and equipment are at touch safe temperatures and
voltage potentials before proceeding.
Projoy accepts No liability for damage from incorrect or careless
operation
Electrical Installation & Maintenance shall be conducted by licensed
electrician and shall comply with Australia National Wiring Rules