Maintenance Guide; Routine Maintenance; Storage And Dismantling - Projoy Prosol-M600 User Manual

5. MAINTENANCE GUIDE

5.1 ROUTINE MAINTENANCE


Only authorized personnel are allowed to carry out the maintenance operations and are
responsible to report any anomalies.

Always use the personal protective equipment provided by the employer when carry out the
maintenance operation.

During normal operation, check that the environmental and logistic conditions are correct.
Make sure that the conditions have not changed over time and that the equipment is not
exposed to adverse weather conditions and has not been covered with foreign bodies.

DO NOT use the equipment if any problems are found, and restore the normal conditions
after the fault removed.

Conduct an annual inspection on various components, and clean the equipment with a
vacuum cleaner or special brushes.
Do not attempt to dismantle the Micro-inverter or make any internal repairs! In order to
preserving the integrity of safety and insulation, the Micro-inverters are not designed to allow
internal repairs!
The AC output wiring harness (AC drop cable on the Micro- inverter) cannot be replaced. If
the cord is damaged the equipment should be scrapped.
Maintenance operations must be carried out with the equipment disconnected from the grid
(power switch open) and the photovoltaic modules obscured or isolated, unless otherwise
indicated.
For cleaning, DO NOT use rags made of filamentary material or corrosive products that may
corrode parts of the equipment or generate electro static charges.
Avoid temporary repairs. All repairs should be carried out using only genuine spare parts.

5.2 STORAGE AND DISMANTLING


If the equipment is not used immediately or is stored for long periods, check that it is
correctly packed. The equipment must be stored in well-ventilated indoor areas that do not
have characteristics that might damage the components of the equipment.

Take a complete inspection when restarting after a long time or prolonged stop.

Please dispose the equipment properly after scrapping, which are potentially harmful to the
environment, in accordance with the regulations in force in the country of installation.
14