Half-Size Pci Express Mini Card Installation - Efco TPC-5215 User Manual

Please to pay heed the SATA cables. The cable be hook at real chassis.
4. Align a SO-DIMM on the slot such that the notch on the SO-DIMM matches the
break on the slot. Firmly insert the SO-DIMM into the slot until the retaining clips
at both ends fully snap back in place and the SO-DIMM is properly seated.
5. Replace the system cover.
1. If you install one memory module only, please install it on DDR3_A1.
2. It is not allowed to install a DDR or DDR2 memory module into a DDR3
slot; otherwise, this motherboard and SO-DIMM may be damaged.
3. Please make sure to disconnect the power supply before adding or
removing SO-DIMMs or the system components.
4. The SO-DIMM only fits in one correct orientation. It will cause
permanent damage to the motherboard and the SO-DIMM if you force
the SO-DIMM into the slot at incorrect orientation.

2.4.2 Half-Size PCI Express Mini Card Installation

1. The step 1 ~ 3 the same Memory installation.
2. Align the card connector with the slot and press firmly until the card is completely
seated on the slot. Fasten the card to the motherboard with screws (M2 x 4mm).
Photo_21 – RAM Slot
18